Sony C37p-

Out of service since the last hammering from a drumstick crushed the grill, and tore the capsule membrane.

I forced out the grill a bit to free up some room and replaced the capsule (sony still sells them). Reskinning is about as expensive as the new one.
Sounds great!

Recapped and tested a couple Altec 539a power supplies (for 195 mic).

EApreq prepwork.

Discovered one of our ATR 1/4" 2-track repro heads is cooked. There was goofiness with adjusting the azimuth and the sensitivity was low. Looking at the actual head, I could see at the top and bottom, the gap was widening ("opening up"). Now to hunt for a replacement. Spares are getting harder to come by.

JSP recapped another set of Altec 195 supplies.

-Elesewhere-

Universal Audio LA-3 reissue-

Gain reduction meter showing maximum attenuation, with no signal present. Compression function, working however.

T4b not working. Swapped it with a companion unit, and all was good. UA's customer service was nonexistent on the phone or online. They had a chat bot who wouldn't stop asking me what OS I was trying to run my real world LA-3. Brian Fox had a spare I bought off him. Thanks.


ITI MEP 230 stereo EQ-

Broken power switch, and low frequency shelf select switch.
No other notes about whether or not it worked. The insides look pretty rough. There are 10 epoxy-encased mystery amps or amps and filters, and the power supply caps are original. These things are notoriously buggy.

Replaced the two switches and powered it up. On the bench, everything seems to be functioning, except the mid band on the left channel did nothing. No listening tests yet.

Studer A820MCH Mkii-

JSP recapped all NRS Control boards (240 bipolar caps).


EAPreq (2-chan rack version) construction.

Finished two EApreqs.

AKG 451E -

No low end.

JSP recapped all the Repro, Record and HF Driver Boards on the Studer A820MCH MKII

Studer A820MCH mkII-

Channel 22 pops when switching between Sync and Repro monitoring.

Swapped Channel 22's Repro/Sync Amplifier and NRS Control boards with two separate channels to narrow it down to the Repro/Sync Amp. Traced the problem to a faulty SD214 MOSFET switch on the Repro/Sync Amplifier board. The the switching control voltage should measure from -15 to +15 volts at the gate. This one was locked at roughy 8 volts in either mode. I'd tell you the location on the schematic, but we don't have the repro half of the Repro/Sync Amplifier 1.820.810 schematic. This was the latest version of the board built to allow sync and repro playback simultaneously. If anyone's got it, please share. I have the complete machine document scans Studer provided before they closed, this isn't in there. If you were looking at the older repro amp board schematic 1.820.710 the part would be IC 6.

Checking for other things...